Who can press new bearings on direct drive shaft?

[Dwain Ray]

Ya Lee....ya gotta drive the new bearing in place by laying the old bearing on top to drive it home....but you knew that..!

This is what i use to replace the bearings in my driveshafts. The aluminum spacer allows me to install bearings without removing the clutch magnet saving alot of time

 

[KevinD]

Ya Lee....ya gotta drive the new bearing in place by laying the old bearing on top to drive it home....but you knew that..!

He knew that 16 years ago when this thread was made.

 

[bob vawter]

All my experience is with sealed straight driveshafts. . As far as greasing goes i would pump grease same as i would on the vans driveshaft, till it seeps outa the seals unless told otherwise by hydramaster..

The CORRECT bearings are sealed and non-greasable

 

[bob vawter]

He knew that 16 years ago when this thread was made.

I'm not sure...wit a Neanderthal looking tool lik that!

 

[bob vawter]

I'm not sure...wit a Neanderthal looking tool lik that!

IMPOSSIBLE !!

 

[bob vawter]

IMPOSSIBLE !!

Ummmm.....you do know that next to Steam Genie.......I've prolly built more Genies than anyone
....